Keyboard/Mouse - Avocent KVM over IP switch User Manual

[confirm] <keycode>[+|-[*]<keycode>]*
"confirm" requests confirmation by a dialog box before the key strokes will be sent to the
remote host.
"keycode" is the key to be sent. Multiple key codes can be concatenated with a plus, or a
minus sign. The plus sign builds key combinations, all keys will be pressed until a minus
sign or the end of the combination is encountered. In this case all pressed keys will be
released in reversed sequence. So the minus sign builds single, separate key presses
and -releases. The star inserts a pause with duration of 100 milliseconds.
6.3.2

Keyboard/Mouse

Host Interface
Enables a certain interface the mouse is connected to. You can choose between "Auto"
for automatic detection, "USB" for an USB mouse, and "PS/2" for a PS/2 mouse.
To use the USB and/or PS/2 interface you need a correct cabling between the
managed host and the managing device. If the managed host has no USB
keyboard support in the BIOS and you have connected the USB cable only then
you will have no remote keyboard access during the boot process of the host. If
USB and PS/2 are both connected and you selected " Auto " as host interface,
then the card will select " USB " if available or otherwise falls back to " PS/2 ".
To get USB remote keyboard access during the boot process of the host, the following
conditions must be fulfilled:
• the host bios must have USB keyboard support
• the USB cable must be connected or must be selected in the Host interface option
Figure 6-17. Keyboard and Mouse Settings
Warning
42
8/16 PS/2 KVM over IP switch