Avocent KVM over IP switch User Manual page 40

terminal or an according emulation, it is even possible to perform a console redirection as
long as the PS/2 IP-KVM switch host machine is using a text mode screen resolution.
Connecting to the PS/2 IP-KVM switch is done as usual and as required by the Telnet client,
for instance in a UNIX shell:
Replace the IP address by the one that is actually assigned to the PS/2 IP-KVM switch. This
will prompt for username and password in order to log into the device. The credentials that
need to be entered for authentication are identical to those of the web interface. That means,
the user management of the Telnet interface is entirely controlled with the according
functions of the web interface.
Once you have successfully logged into the PS/2 IP-KVM switch a command line will be
presented and you can enter according management commands.
In general, the Telnet interface supports two operation modes: the command line mode and
the terminal mode. The command line mode is used to control or display some parameters.
In terminal mode the pass-through access to serial port 1 is activated (if the serial settings
were made accordingly). All inputs are redirected to the device on serial port 1 and its
answers are displayed on the Telnet interface.
The following list shows the according command mode command syntax and their usage.
help
Displays the list of possible commands
cls
Clears the screen
quit
Exits the current session and disconnects from the client
version
Displays the release information
terminal
Starts the terminal passthrough mode for serial port 1. The key sequence esc exit
switches back to the command mode. The command has an optional parameter (1 or 2)
to select the desired serial port for passthrough access.
telnet 192.168.1.22
37
8/16 PS/2 KVM over IP switch