Avocent KVM over IP switch User Manual page 28

a. The "OSD: 10 SEC" means that the OSD windows display or PC system name exists 10 sec.
on your monitor. You can modify it from 05 sec to 99 sec. The factory default value is 10 sec.
b. The "SCAN TIME" means that scan interval from one PC port to next PC port. The default
SCAN time is 10 sec and the maximum scan time is 99 sec.
c. The "CHANGE PASSWORD" is for user to avoid all PC systems to be intruded by the other
person. The default password is 8 digits "00000000".
There is an enter password window showed out when you select this item and then press
the Enter. The maximum password is 8 digits. After you key in the password already and
press the Enter key, there is another window for confirming your typed password.
You need to retype the password again for rechecking your previous key-in password is
matched or not.
d. The " CONSOLE ON/OFF " means to manage the console of KVM switch. If you select
" CONSOLE ON ", it means that any user can use the console. If you select " CONSOLE
OFF "(factory default OFF state), it means that any user will not be allowed to use the
console unless you enter the password. When you enter the password already and pass the
KVM switch authentication, the CONSOLE will be set to ON. After you finish using KVM
switch, please don't forget to set up CONSOLE ON state to OFF state. Besides, if current
CONSOLE is ON state and you reset KVM switch, the CONSOLE will be set up ON state
back to OFF state.
e. When you finish the set up of PC name and get out of OSD setting mode, you will find the
PC name showed at the up-left corner of monitor. Now, you can use ESC key to clear the
message right away if you don't need it.
f. If you want OSD returning back to factory default value, you can execute "SCROLL LOCK",
"SCROLL LOCK" , "R" keys in order. The bank seven segment LED on the front panel will
25
8/16 PS/2 KVM over IP switch