Inserting The Input Boards And Output Boards - Sony CSP-5000E Service Manual

Preparation
Inserting the Input Boards and
Output Boards
Insert the CSPB-510VC Input Boards (not supplied)
and CSPB-520VC Output Boards (not supplied) into
the system controller.
An input board inputs eight video signals, and an
output board outputs eight video signals.
The system controller is equipped with 16 slots for the
input boards and four slots for the output boards.
Insert the required number of boards.
Setting the jumber pins on the output
boards
Before inserting the output boards, set the jumper pins
on the output boards as follows, in accordance with the
slot number the board is to be inserted into.
VB1
VB9
VB17
VB25
VB2
VB10
VB18
VB26
VB3
VB11
VB19
VB27
VB4
VB12
VB20
VB28
VB5
VB13
VB21
VB29
Output board VB6
VB14
VB22
VB30
VB7
VB15
VB23
VB31
VB8
VB16
VB24
VB32
Jumper pins
10(EN)
Setting the jumper pins on the output boards
Jumper pin Slot 1 Slot 2 Slot 3 Slot 4
CN105 VB1 VB9 VB17 VB25
CN106 VB2 VB10 VB18 VB26
CN107 VB3 VB11 VB19 VB27
CN108 VB4 VB12 VB20 VB28
CN109 VB5 VB13 VB21 VB29
CN110 VB6 VB14 VB22 VB30
CN111 VB7 VB15 VB23 VB31
CN112 VB8 VB16 VB24 VB32
Inserting the boards
Caution
Do not insert and remove the boards while the power
is turned on.
Stopper
Stopper
1
Open the front panel.
2
Insert the input boards into one of the 16 slots (slot
1 to 16) of the right side, and insert the output
boards into one of the four slots (slot 1 to 4) of the
left side.
3
Secure the board using the stopper.
4
Close the front panel.
Video input/output numbers
The video input and output numbers of the terminals
on the input/output boards are determined by the slot
you inserted the boards.
Video input number Slot number
1 - 8 1
9 - 16 2
17 - 24 3
25 - 32 4
33 - 40 5
41 - 48 6
49 - 56 7
57 - 64 8
65 - 72 9
73 - 80 10
81 - 88 11
89 - 96 12
97 - 104 13
105 - 112 14
113 - 120 15
121 - 128 16
Video output number Slot number
1 - 8 1
9 - 16 2
17 - 24 3
25 - 32 4
11(EN)