Clearing The Defined Preset Position; Defining The Pan/Tilt Pattern - Sony CSP-5000E Service Manual

Configuring the System

Clearing the defined preset position

If you have set up preset positions for a camera, you
can clear them using the steps below.
1
Select a camera you have set up preset positions
and pan/tilt patterns for.
2
From the main menu, select "P/T" and then press
the SET key.
P/T
→
PRESET
PATTERN
3
Select "PRESET," and then press the SET key.
PRESET
→
SET
CLEAR
4
Select "CLEAR," and then press the SET key.
PRESET(CLEAR)
INPUT CLEAR NUMBER
→
40(EN)
5
Enter the preset number you want to clear. Finally,
press the SET key to accept the changes.
If there are additional preset positions for this
camera that you want to clear, you can repeat this
step to clear them.
6
When you are ready, press the MENU key.

Defining the pan/tilt pattern

You can define the pan/tilt pattern, up to 30 seconds,
for the currently selected camera.
The defined pan/tilt pattern can be recalled by the
PATTERN key.
Note that this function can be used only with specific
pan/tilt units.
1
Select a camera you want to define the pan/tilt
pattern for.
2
From the main menu, select "P/T" and then press
the SET key.
P/T
→
PRESET
PATTERN
3
Select "PATTERN," and then press the SET key.
PATTERN
START POINT
PRESS SET KEY
4
Press the SET key.
The menu changes to the following.
PATTERN
END POINT
PRESS SET KEY
5
Create a camera move pattern using the pan/tilt
unit, for up to 30 seconds, then press the SET key
again.
41(EN)