TIMED/MANUAL Switch is TIMED.
•
The Timer is zeroed, with the dial pointing to the 0 mark.
•
5.
If the Timer is not zeroed, turn the dial counterclockwise until it points to the 0 mark.
6.
Timed Test 1 Start timing upon turning the ON/OFF Switch to ON.
Turn the ON/OFF Switch ON.
a. Immediately:
The red ON/OFF Switch light turns on.
•
The fill valve opens and the steam generator fills with water.
•
The buzzer sounds for 3 seconds.
•
b. 3 Minutes
Water appears in the bottom of the float/probe assembly cylinder as the steam
•
generator fills.
NO water flows from the drainpipe.
•
Check for plumbing leaks.
•
c. 4 Minutes
The fill valve closes with a clicking sound.
•
The water level in the float/probe assembly cylinder stops rising about an inch from the
•
top of the cylinder. If the water continues to rise, STOP, shut down, and call your qualified
Cleveland Range authorized Service Representative.
7.
Timed Test 2: Start timing upon pressing the MANUAL end of the TIMED/MANUAL Switch.
Press the MANUAL end of the TIMED/MANUAL Switch
f.
Immediately:
The condenser solenoid clicks open and condenser flow starts.
•
The heater coil turns on when the float/probe assembly cylinder water level is 1 inch from
•
the bottom of the float/probe assembly cylinder.
g. 2-5 Seconds:
A small stream of water flows from the drainpipe. If no water flows make sure the water
•
supply valves are open.
h. 2 Minutes:
A dull roaring sound indicates the heater is working and steam is being produced.
•
i.
3-4 Minutes:
Steam begins to enter the cooking compartment through the nozzles. (A small amount of
•
water may drip from the nozzles until steam clears the lines.)
j.
4-5 Minutes:
Steam from the nozzles begins to fill the cooking compartment.
•
8.
Timed Test 3: Zero the Timer and start timing upon pressing the TIMED end of the
TIMED/MANUAL Switch.
Press the TIMED end of the TIMED/MANUAL Switch
a. Immediately:
The heater turns OFF.
•
The condenser flow stops.
•
The buzzer sounds for 3 seconds.
•
b. 30 Seconds:
Steam stops entering the cooking compartment.
•
9.
Open the cooking compartment door for 2-3 minutes to allow it to cool slightly.
10.
Close the cooking compartment door and continue testing.
22