Cleveland SteamCraft 21CET8 Operation Installation Maintenance Manual page 29

11. Set the TIMED/MANUAL Switch to TIMED.
12. Set the Timer for 10 minutes.
13. As soon as the Timer dial is released, the steam generating cycle starts. The same sequence
observed in 6 and 7 repeats, EXCEPT:
The Dial Timer controls the cycle.
•
The elapsed times are shorter because the steam generator and cooking compartment are
•
already hot.
The Dial Timer starts the functions observed in 8 after counting down to 0.
•
14. After setting and releasing the Timer dial, observe the following steam generating functions:
a. When the float/probe assembly cylinder water level is 1 inch from the bottom of the cylinder,
the heater coil turns on. A dull roaring sound indicates the heater is working and steam is
being produced.
b. The condenser solenoid clicks open and a small stream of water flows from the drainpipe.
c. When the float/probe assembly cylinder water level drops below the initial fill level, the water
fill valve opens and fills the generator.
d. As steam is generated, the water level rises and falls and a clicking sound indicates the
solenoid valve is opening and closing the fill valve. The level in the float/probe assembly
cylinder rises and falls about ¼ inch as the fill valve operates.
e. Check for steam leaks around the cooking compartment door.
f. When the Timer counts down to zero, the heaters turn off, the condenser flow stops, and the
buzzer sounds continuously. Press the START/STOP key to silence the buzzer.
g. After about 30 seconds, steam stops entering the cooking compartment.
15. Turn the SteamCraft off by pressing the OFF end of the ON/OFF switch. The red indicator light
goes out and the 3-minute automatic blowdown cycle starts.
16. After the blowdown is complete, turn OFF the Main External Power Switch.
17. Replace the side panel. After passing all the tests, the SteamCraft is ready for use.
23