Connecting To A Modem For Remote Management - Paradyne Hotwire 8610 DSLAM Installation Manual

Connecting to a Modem for Remote Management

Before connecting the Hotwire 8610 DSLAM to a dial-up modem, configure the
modem with the following settings:
T
T
T
T
Procedure
To connect the Hotwire 8610 DSLAM chassis to a dial-up modem:
8610-A2-GN20-10
Set the modem for auto answer. For example, ATS0=1.
Turn off character echo. For example, ATE0.
Enable result codes in originate mode only. For example, ATQ2.
Set the modem to ignore Data Terminal Ready (DTR). For example, AT&D0.
1. Connect an 8-pin modular plug-ended serial cable into the MANAGEMENT
SERIAL port of the 8610 chassis.
2. Dress the serial cable under the 8610 chassis, to the left and behind the
support foot.
3. Plug the other end of the cable into your modem's serial port using a DB25
(RS-232 male) adapter, supplied with the MCP card, and a Null Modem
adapter.
Management Serial
MANAGEMENT
5
6
4
3
2
1
STACK
POSITION IN OUT SERIAL ALM INTF MCP/1
April 2001
10/100 BASE T
3
2
DB25 Null
Adapter Modem
3. Cabling
Dial-up
Modem
00-16326-01
3-5