Table of Contents
Advertisement
1. Introduction
Hotwire 8610 DSLAM Components
The Hotwire 8610 DSLAM consists of the following components:
T
T
T
Before installing the Hotwire 8610 DSLAM, read the
located at the front of this document.
1-4
For a list of specific management information bases (MIBs) supported, visit
the Paradyne Web site at www.paradyne.com. Select Online Support →
MIBs .
TM
TM
8610
ESD
ESD
MCP/
DSL
DC FUSES
48VDC CLASS 2
T4A, MIN. 48V
OR LIMITED
PWR SOURCE
AC
INPUT
A
A
B
A B
48V
RTN
Hotwire 8610 DSLAM base chassis
Hotwire 8610 DSLAM is a 3-slot chassis designed to house one MCP card in
the first slot and up to two DSL cards in the remaining slots. Since the MCP
card in the 8610 system can provide management connectivity for up to five
other 8610 DSLAMs, these other systems can use the first slot for a DSL card,
thus housing up to three DSL cards.
One Management Control Processor (MCP) card
The Hotwire 8610 DSLAM requires one MCP card mounted in Slot 1 of the
base, or first, chassis in a stack. The MCP card is a processor card that
administers and provides diagnostic connectivity to DSL cards in from one to
six 8610 DSLAMs. It acts as a mid-level manager and works in conjunction
with an SNMP network management system, such as OpenLane, via its LAN
port. It gathers operational status for each of the DSL cards and responds to
the SNMP requests. It also supports a serial port for local terminal access.
At least one Digital Subscriber Line (DSL) card
The 8610 DSLAM requires at least one DSL card. Each DSL card contains a
number of DSL ports (depending on model), Ethernet interface circuitry, and a
processor. The processor controls the modems and forwards the packet traffic
to and from the Ethernet and DSL interfaces.
NOTE:
You must order the MCP and DSL cards separately. They are not provided
with the chassis.
April 2001
MANAGEMENT
FAN
PWR
5
4
6
3
2
1
ALM
A
B
B
STACK
IN
OUT
SERIAL
ALM INTF
POSITION
Important Safety Instructions
3
2
1
10/100 BASE T
MCP/1
2
3
00-16311a-01
8610-A2-GN20-10
Advertisement
Table of Contents
