Table of Contents
Advertisement
-
The equipment weight 70kg(154lbs) and the maximum lateral load 400N
(40kg/88lbs) are shown in the load plate. Another load plate is located next the control
valve at the ground control station.
Warning plate
The following warning plates can be found in the ground control station and in the platform.
An instruction decal for operating the emergency lowering system can be found on the
engine hood.
-
working near live electrical conductors
-
a decal with instructions for operating the outriggers: SECURE STABILITY. EVEN
ASPHALT CAN YIELD!
-
maximum load
-
voltage decal
-
warning for high sound pressure level at the ground control station
-
inspecting the condition of the Access Platform and testing before work (= daily
inspections)
-
steps to be taken in case of malfunction during work
-
general instructions for the operators
Outrigger plate
The maximum supporting load and instructions for the use of extra boards must be
permanently and clearly marked at the place where the outriggers are operated.
The supporting load is 22500N (2300kg/5060 lbs)), when the boom with maximum load is
slewed above the outrigger in question.
The soil tightness table on page 38 of the manual will help to define the need of extra
boards.
Please also note the local building regulations and special regulations for each building
site.
The outriggers and their operating levers are identified with numbers 1-2-3-4.
Hazard colours
The Access Platform must be clearly visible. All projecting parts must be clearly marked.
Projecting parts are sections reaching outside the chassis, i.e. the outriggers and the
working platform. The projecting parts are marked with yellow/black diagonals. The
diagonal striping is best visible in the site environment.
General information:
-
the striping is marked with yellow-black decals
-
the decals on the sides of the outriggers
-
the decals in the base strip of the working platform
Operating zone diagram
The operating zone diagram can be found in the manual and in the working platform. In
the manual, the diagram is on page 11.
Inspection plate
The inspection plate, onto which the inspector stamps his initials and the date, is riveted in
a visible place in the rear part of the chassis.
NOTE! All damaged or unclear plates and decals should be replaced with new ones
immediately, before the next use of the Access Platform.
Kesla
SELF PROPELLED TELESCOPIC PLATFORM
64
XS
®
190
Advertisement
Table of Contents
