Table of Contents
Advertisement
SERVICE PROGRAMME FOR DIESEL ENGINE
KUBOTA D205E DIESEL ENGINE
The diesel engine is Kubota D905E.
The maximum speed of the engine has been adjusted to approx. 2700 rpm. This speed
should not be exceeded. The top speed is needed when driving in difficult terrain. When
adjusting the engine speed, 1500 rpm should be considered as the minimum level. Due to
the variable displacement hydraulic pump the speed of the boom movements does not
change along with the engine speed. In low temperatures, approx. –5°C or below, use the
cold start device to start the engine.
The Kubota Diesel engine has a quick preheating operated with the main switch key.
Starting and stopping the Kubota D905 Diesel engine
Starting:
1.
Switch on the power with the main power switch. The key may be removed also
when the power is switched on.
2.
Start the engine from the platform if you intend to use the Access Platform from the
platform. Similarly, if you intend to use the Access Platform from the ground station, start
the engine from main power switch at the ground station. When using the Access Platform
from the ground station, the Access Platform should at first be supported on the outriggers.
See "USING THE BOOM FROM THE GROUND STATION". The selection of the control
station depends on whether the engine was started from the platform or from the ground
station. The selection of the control station depends on from where the engine was started.
In cold weather, –5°C or below, keep the key in the preheat position as long as the preheat
signal lamp is on. After this, start the engine by turning the key to position START. Let the
engine idle until it has warmed up to the operation temperature.
Stopping:
1.
Turn the key position 0 (OFF) to stop the engine.
Kesla
SELF PROPELLED TELESCOPIC PLATFORM
46
XS
®
190
Advertisement
Table of Contents
