Checking The Hydraulic Oil, Adding Oil - Kesla XS 190 Operation & Maintenance Manual

CHECKING THE HYDRAULIC OIL, ADDING OIL

1. Check the hydraulic oil level with the boom on the transport support, the telescope
fully retracted, and all outriggers fully up.
2. Remove the left-hand side cover over the turntable, seen from the platform.
3. Check the oil level in the sight glass of the oil tank. The top level is the top edge of
the sight glass, the bottom level is the lower edge of the sight glass.
4. Add oil as required.
• Clean the filler plug and the surround or the filler opening.
• Remove the plug. Note: The filler plug has a valve for maintaing a small
overpressure in the tank. The overpressure is normally released when the plug is opened.
• Add oil using a filtered pump unit. Do not fill oil pouring it directly from a container.
Oil recommendations, see page 51.
• Check oil level, see illustration below.
5. Close the filler plug and reinstall the side cover.
Oil level sight glass
Top limit
Lower limit
Kesla
SELF PROPELLED TELESCOPIC PLATFORM
52
XS
®
190