Table of Contents
Advertisement
Failure messages for the platform load control
In case the platform load control fails, open the door of the control panel and check if there
is one of the following failure messages in the display:
ER 10
Outside measuring range
ER 21
LO or HI values not correct
ER 22
Sensor overloaded
ER 23
HI value too high
ER 24
The load difference too small
ER 30
Failure in the control electronics
ER 70
Problem in wiring
Kesla
SELF PROPELLED TELESCOPIC PLATFORM
25
XS
®
190
Check the mechanical lever system for
being stuck.
Contact
the
instructions
Replace the horizontal overload sensor
Contact the manufacturer for instructions
Check the mechanical lever system for
being stuck.
Replace the control electronics and
perform adjustment as instructed.
Check wires and connections
manufacturer
for
Advertisement
Table of Contents
