Maintenance; Periodic Maintenance; Maintenance Scheme Based On Operating Hours - Kesla XS 190 Operation & Maintenance Manual

MAINTENANCE

The Access Platform must be maintained regularly in order to keep it safe and efficient.
For descriptions of the necessary service procedures, refer to the maintenance scheme
and annual inspection list. If you feel uncertain about carrying out maintenance, do not
hesitate to contact a service shop specialized in Access Platforms for the maintenance
work and inspections needed.

PERIODIC MAINTENANCE

Carefully ensure cleanliness before opening hydraulic or fuel lines.
Change the engine oil after the first 50 hours of operation.
In normal conditions, change the oil again after 50 hours of operation; change also the oil
filter. In extremely dusty, hot or heavy environment or when the work load is exceptionally
high, the oil should be changed at intervals of 25 hours of operation. Use washing motor
oil, category SF. The required viscosity depends on the ambient temperature. Refer to the
table in the engine manual.
- Change hydraulic oil and filter. The oil change intervals should be shortened in
dusty, humid or corroding environment, if the ambient temperature varies greatly, or if the
Access Platform is very heavily loaded.

MAINTENANCE SCHEME BASED ON OPERATING HOURS

Daily
Weekly
50h intervals
500h intervals
1000h intervals or
at least every 6
months
12 month intervals
The Access Platform in the transport position
*) the Access Platform should in horizontal position, both lengthwise and crosswise
- the oil level should be between Min and Max marks
**) see instruction on page 60
Kesla
SELF PROPELLED TELESCOPIC PLATFORM
1. Check fuel level
2. Check load-bearing structures
3. Check hydraulic hoses and pipes and tightness of hydraulic
couplings
4. Check the functioning of emergency stop and safety devices
5. Check all directions of functions. The functions should return
automatically to neutral positions.
1. Check hydraulic oil level *
1. Lubricate all bearings and sliding surfaces
2. Check the condition of telescope sliding pads and surfaces,
lubricate and adjust as required
1. Change hydraulic oil and filter
2. Check how the boom movements can be stopped
1. Check the condition of driving brakes, clean, adjust and
lubricate
1. Annual inspection. Fill, sign and date the enclosed journal
form.
2. Check the tightness of the slewing gear fastening bolts **)
3. Check the boom extension chains
XS
®
190
45