Serial Number Location; Unit Dimensions; Component Locations; About Pwrcell Inverters - Generac Power Systems XVT076A03 Installation And Owner's Manual

General Information

Serial Number Location

Refer to Figure 2-2 to locate unit serial number (D).
Record the information from this tag in
Inverter Important Information
of this manual.

Unit Dimensions

A
B
Figure 2-1. Unit Dimension
A
24-3/4 in (628 mm)
B
19-3/8 in (491 mm)
C
8-3/8 in (214 mm)

About PWRcell Inverters

The PWRcell Inverter connects to PV Link™ optimizers and PWRcell Batteries to form the PWRcell system for grid-
interactive solar-plus-storage. Upon the loss of grid power, PWRcell Inverters disconnect from the grid and provide AC
power to support protected loads when configured to do so. This capability is referred to as islanding. For more
information, see Island Mode
PWRcell Inverters use the REbus™ 380VDC nanogrid to connect to DC-coupled PWRcell devices. The REbus
nanogrid automates the flow of power to enable plug-and-play setup and operation of PWRcell equipment. For more
information about REbus, visit www.generac.com. In
optimizers (B) and PWRcell Battery (C) on DC (REbus) lines (D). To the right of the inverter are AC lines: 120/240 VAC
or 208 VAC for grid and home loads (G) and protected loads (H).
.
A
B B
A Solar Panels
B PV Link
C PWRcell Battery
6
Table 1: PWRcell
on the inside front cover
C
009955
in Section 6.
C
D
B
Figure 2-3. Generac PWRcell System Example
D REbus
E PWRcell Inverter
F
Grid

Component Locations

A
B
Figure 2-2. Component Locations
A
Control Panel
B Intake Filter
C Exhaust Vent
D Serial Number Tag
PWRcell Inverter (E) is directly connected to PV Link
Figure 2-3
E
D
G
H
Installation and Owner's Manual for Generac PWRcell Inverter
F
Loads
Protected Loads
C
D
009654
G
H
009893