Settings On The Ready-To-Use Device; Setting The Target Temperature - RADEMACHER DuoFern 9433-1 Translation Of The Original Installation And Commissioning Manual

i

9. Settings on the ready-to-use device

The display switches off automatically to save energy.
/
i

9.1 Setting the target temperature

/
You can adjust the desired target temperature in
0.5 °C steps by briefly pressing the button.
Pressing and holding a button causes the numbers to pro-
gress quickly.
i
16
/ Pressing any button
switches on the display again
and switches the DuoFern Radiator
Actuator 2 to operating mode.
The normal display then appears
with the set target temperature.
The room temperature measured by the DuoFern
Radiator Actuator 2 may vary from the perceived
temperature depending on the installation location.
EN