Having The Outlet Hose Connected; Connecting The Inlet Hose - Hanseatic HG6085C14T7635EI User Manual

Page EN-30 Set-up, connection and initial start-up
Having the outlet hose
connected
NOTICE
Malfunction!
Failing to connect the appliance correc-
tly may cause malfunctions during ope-
ration.
■ Make sure that the waste water can
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
■ Ensure that there are no kinks or da-
mage to the outlet hose.
■ Make sure that the end of the hose is
not submerged in the pumped water.
■ Do not extend the outlet hose or
replace with another drainage pipe.
You can connect the end of the outlet hose in
two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (siphon)
of your washing/dishwashing basin. Techni-
cal measures are required for this. For this
reason, only plumbing experts or members
of our service team may connect the out-
let hose (see page EN-38). The outlet hose
must be a maximum of 1000 mm above the
floor.
Ø ≥ 40 mm

Connecting the inlet hose

NOTICE
Risk of damage to property!
The appliance is designed for a wa-
ter pressure of 0.4 to 10 bar (0.04 to
1.00 MPa). Water must always be able
to run freely into the dishwasher, other-
wise this can damage the appliance.
■ If the water pressure is higher than
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
■ Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
■ Ensure that the inlet hose is not kin-
ked and is carefully connected.
■ Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist ("Service" see
page EN-38).
■ Do not use old or previously installed
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with a
¾ inch screw connector.