Error Messages In Basic Fixed Code Operating Mode - Pepperl+Fuchs IVI-KHA6-4HRX Manual

IDENT-I • IVI-KHA6-4HRX, IVI-KHD2-4HRX
Commands

6.1.5 Error messages in basic fixed code operating mode

Error messages are transmitted via the serial interface in response to certain events.
These messages take the form of a letter and error number representing the type of
error. The messages are identical in normal and binary modes. Each error message
is terminated with <CR><LF>.
Error messages in data format 10:
Error message
E0
E1
E2
E3
M5
M9
E9
Error messages in data format 28:
Error message
M0
M1
M2
M3
M4
M5
M6
M7
M8
M9
Subject to reasonable modifications due to technical advances.
20
Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com
Description
The read head to be interrogated is not connected or not
ready
Hardware error in control interface unit
No code carrier or data carrier in position, or data transfer is
not possible
Unable to read code carrier or data carrier
Binary mode cannot be used in the selected data format
Unable to communicate with read head
Unable to understand the command received, or parity error
or check sum error in the serial communication
Description
Hardware error in control interface unit, Watchdog Reset
Memory error in control interface unit after RAM test
Memory error in control interface unit after ROM test
Received command has not been understood
Parity error in the serial communication or check sum error
Binary mode is not permissible in the selected data format
The interrogated read head is not connected or not ready
No code carrier or data carrier is available, or the transfer of
data is not possible
Parity error during data transmission with code carrier or data
carrier
Read head cannot be interrogated
Copyright Pepperl+Fuchs, Printed in Germany