PRONAR T780 Translation Of The Original Instructions page 21

• Cut-off valve in the hydraulic tipping system limits the tipping angle of the load box
when tipped to the sides. The length of the control cable controlling this valve is
factory adjusted by the manufacturer and must not be changed when the trailer is
used.
• People or animals must not be carried.
• Keep a safe distance from electric power lines during unloading.
• Tipping the load box must be done on hard and level ground.
• When opening load box sidle wall locks take particular care, because of the pressure
of the load on the wall.
• Do NOT tip of the load box in windy conditions.
• When closing the rear grain chute gate or the walls take particular care to avoid
crushing fingers.
• Bulk materials loaded in excess of 1 m can be unloaded by tipping the load box to the
rear only.
• Tipping may only be performed when trailer is hitched to tractor.
• Assembly and disassembly of extension walls, the frame and canvas cover, can only
be carried out with the use of appropriate platforms, ladders or from a ramp. These
tools must be in good condition to fully protect the persons working on them against
falling. The above procedure should be performed by at least two persons.
• In the final phase of folding the canvas cover, at all times hold with one hand the
railing of the fenced platform or top of the front frame. Non-compliance with this rule
can put the user at risk of falling.
• In the event of a fault in the hydraulic or pneumatic system, disconnect the trailer from
use until the fault has been fixed.
• When connecting the hydraulic conduits to the tractor, make sure that the hydraulic
systems of the tractor and trailer are not under pressure.
• Check condition of machine hydraulic system frequently, oil leaks are not permissible.
• Do NOT perform any maintenance or repairs on the load box that is loaded, raised or
not supported.
2.4