Mercedes-Benz E-Class 2009 Owner's Manual page 275

Flat tyre
272
Place the emergency spare wheel onto the
X
centring pin and push it on.
Tighten the wheel bolts until they are fin-
X
ger-tight.
Unscrew the centring pin.
X
Tighten the last wheel bolt until it is finger-
X
tight.
Lowering the vehicle
Lower the vehicle. To do this, turn the crank
X
of the jack anti-clockwise until the vehicle
is once again standing firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
X
wise pattern in the sequence indica-
ted (: to A). The tightening torque is
130 Nm.
G
Risk of accident
Have the tightening torque checked immedi-
ately after a wheel is changed. The wheels
could work loose if they are not tightened to
a torque of 130 Nm.
Turn the jack back to its initial position and
X
store it together with the rest of the vehicle
tool kit in the stowage well under the boot
floor.
Vehicles with the "Minispare" emergency
spare wheel*:
Transport the faulty wheel in the boot.
X
i
When you are driving with the "Minispare"
emergency spare wheel* fitted, the tyre
pressure loss warning system* cannot
function reliably.
MOExtended run-flat system*
The MOExtended run-flat system may only be
used in conjunction with the activated tyre
pressure loss warning system.
! The maximum permissible distance which
can be driven in run-flat mode depends on
the load in the vehicle. It is 80 km if the
vehicle is partially laden and 30 km if fully
laden.
* optional