Mercedes-Benz E-Class 2009 Owner's Manual page 270

Hide thumbs Also See for E-Class 2009:
Table of Contents

Advertisement

Version 2
Pull connector ? with cable and air pump
X
hose A out of the housing.
Screw air pump hose A onto flange B of
X
TIREFIT sealant filler bottle :.
Place TIREFIT sealant filler bottle : head
X
downwards into recess ; of the electric
air pump.
Remove the cap from valve C on the faulty
X
tyre.
Screw filler hose D onto valve C.
X
Insert connector ? into the socket of the
X
cigarette lighter* (
Y
12 V power socket (
vehicle.
Vehicles without KEYLESS GO*: turn the
X
key to position 2 (
Y
lock.
Vehicles with KEYLESS GO*: press the
X
Start/Stop button twice (position
2 (
page 66)).
Y
* optional
page 173) or into a
page 174) in your
Y
page 65) in the ignition
Press on/off switch = on the electric air
X
pump to I.
The electric air pump is switched on. The
tyre is inflated.
i
First, TIREFIT is pumped into the tyre. The
pressure can briefly rise to around 5 bar.
Do not switch off the electric pump dur-
ing this phase.
Let the electric pump run for five minutes.
X
The tyre should then have a pressure of at
least 1.8 bar.
! Do not operate the electric air pump for
longer than eight minutes at a time without
a break. It may otherwise overheat.
The air pump can be operated again once
it has cooled down.
If a pressure of 1.8 bar is not reached
after five minutes:
Switch off and disconnect the electric air
X
pump and drive the vehicle forwards or
backwards approximately 10 m.
This distributes the TIREFIT more evenly.
Remove TIREFIT sealant filler bottle :
X
from the electric pump.
Pump up the tyre again.
X
G
Risk of accident
If a pressure of 1.8 bar is not achieved after
five minutes, the tyre is too badly damaged.
Do not drive any further. Consult a qualified
specialist workshop which has the necessary
specialist knowledge and tools to carry out
the work required. Mercedes-Benz recom-
mends that you use a Mercedes-Benz Service
Centre for this purpose. In particular, work
relevant to safety or on safety-related sys-
tems must be carried out at a qualified spe-
cialist workshop.
Flat tyre
267
Z

Advertisement

Table of Contents
loading

Table of Contents