Mercedes-Benz E-Class 2009 Owner's Manual page 166

Closing the boot separator
Pull boot separator : by the handle in the
X
direction of the arrow until it rests on the
sides of the boot.
The boot separator finishes closing auto-
matically.
Opening the boot separator
Press boot separator : by the handle
X
against the direction of the arrow.
The boot separator finishes opening auto-
matically.
Draught stop*
The draught stop protects against wind when
driving with the soft top open. It is located in
a bag in the boot. The draught stop is secured
above the rear bench seats. For this reason,
only the driver and the front passenger can
travel in the vehicle when the draught stop is
fitted.
G
Risk of accident
You could cause an accident if your rear view
is limited by darkness or other conditions.
Therefore, fold back the upper section of the
draught stop if it restricts your vision or when
it is dark.
! Observe the backrest position of the front
seats if the draught stop is installed, since
* optional
Soft top (Cabriolet)
the backrest could collide with the draught
stop here.
Fitting
Take the draught stop out of the bag.
X
Fold upper section : and lower sec-
X
tion ; together.
Push the retainer of top section : into the
X
snap fastener of lower section ;.
Retaining lugs
=
Retaining pin, right
?
Catch for retaining pin, left
A
To lock
6
To unlock
7
Fold out retaining lugs =.
X
Simultaneously push right-hand-side
X
retaining pins ? of the assembled draught
stop into the right-hand side mounting and
retaining lugs = into the openings for the
seat belts.
163
Z