64
DCx camera
No.
Error message
120
IS_ALL_DEVICES_BUSY
122
IS_TIMED_OUT
125
IS_INVALID_PARAMETER
127
IS_OUT_OF_MEMORY
139
IS_NO_USB20
140
IS_CAPTURE_RUNNING
145
IS_IMAGE_NOT_PRESENT
148
IS_TRIGGER_ACTIVATED
151
IS_CRC_ERROR
152
IS_NOT_YET_RELEASED
153
IS_NOT_CALIBRATED
154
IS_WAITING_FOR_KERNEL
155
IS_NOT_SUPPORTED
157
IS_OPERATION_ABORTED
158
IS_BAD_STRUCTURE_SIZE
159
IS_INVALID_BUFFER_SIZE
160
IS_INVALID_PIXEL_CLOCK
161
IS_INVALID_EXPOSURE_TIME
162
IS_AUTO_EXPOSURE_RUNNING
163
IS_CANNOT_CREATE_BB_SURF
164
IS_CANNOT_CREATE_BB_MIX
Description
1 to 255.
All cameras are in use.
A timeout has occurred. An image could not be
fully captured within the specified time.
One of the parameters passed is outside the
valid range, not supported for this sensor, or
not available in this mode.
Could not allocate memory.
The camera is connected to a port that does
not support the high-speed standard USB 2.0.
Cameras with no memory cannot be operated
on USB 1.1 ports.
A capture is already in progress and must be
completed before a new one can begin.
The required image is no longer in the camera's
memory or no longer valid.
This function is not possible because the
camera is waiting for a trigger signal.
A CRC error has occurred while reading the
settings.
This function is unfortunately not yet available
in this driver version.
The camera contains no calibration data.
Waiting for response from kernel driver.
The camera model you are using does not
support this function or setting.
No file was saved because the dialog was
closed without a selection being made.
An internal structure has the wrong size.
The image buffer is the wrong size for capturing
an image in the desired format.
This setting is not possible with the currently
set pixel frequency.
This setting is not possible with the currently
set exposure time.
This setting cannot be changed as long as
automatic exposure time control is active.
BackBuffer Surface cannot be created.
BackBuffer Mixer Surface cannot be created.
© 2010 Thorlabs
Need help?
Do you have a question about the LabView DCU2 Series and is the answer not in the manual?