Step 3. Cable The Sc-2345/2350 Carrier To The Daq Device - National Instruments SCC Series Quick Start Manual

Step 3. Cable the SC-2345/2350 Carrier to
the DAQ Device
Refer to the Read Me First: Safety and Radio-Frequency Interference document
Caution
before removing equipment covers or connecting/disconnecting any signal wires.
SCC Quick Start Guide
The DAQ device should already be installed in your computer. Refer to the
DAQ Quick Start Guide for installation instructions.
Connect the SC-2345/2350 carrier to the DAQ device with a 68-pin
shielded cable. If you are using an M Series DAQ device with two
connectors, connect the cable to connector 0 or 1. Use connector J24,
shown in Figure 2, on the SC-2345/2350 carrier.
3
1 Connector J24
Figure 2. Connector J24 Location
The chassis ground terminal on the SC-2345/2350 carrier and the
electromagnetic interference (EMI) gasket attached to the strain relief of
the SC-2345 connector block are for grounding a floating source (1 mA
maximum). Do not use these terminals as safety earth grounds. For more
information about the SC-2345/2350 carrier, refer to the SC-2345/2350
Carrier User Manual.
2 Power LEDs
6
1
2
3 SC-2345 Carrier
ni.com