Procedure 2: Apply I/O Panelette Labels - National Instruments SCC Series Quick Start Manual

Panelette
LEMO (B-Series)
MIL-Spec
9-pin D-sub
Momentary switch
Toggle switch
Rocker switch
LED
Potentiometer
Strain relief
Blank

Procedure 2: Apply I/O Panelette Labels

© National Instruments Corporation
Table 1. Panelette Options (Continued)
Description
2-pin female
4-, 6-pin female
2-, 4-, 6-pin female
Single (male)
Single (female)
Dual (male)
Dual (female)
On – off
(on – off – on)
(on – off – on)
Red, green, yellow, and orange LEDs
1 turn, 10
Small strain relief
Filler panel
You can install a blank panelette into any unused panelette opening.
Complete the following steps to install the I/O panelettes:
1. Remove the blank panel before installing any I/O panelettes on the rear
of the SC-2345/2350 with configurable connectors.
2. Place the lower edge of the I/O panelette in the groove at the bottom of
the enclosure opening.
3. Tilt the panelette top back into the enclosure.
4. Secure the panelette with either one, two, or three (depending on the
type of I/O panelette) M2.5 × 6 panhead screws that are included with
the panelette.
5. Connect the lead wires from the panelette to the screw terminals of the
SCC modules or to the 42-pin screw terminal block inside the
SC-2345/2350 carrier.
The SC-2345 with Configurable Connectors and the SC-2350 are shipped
with a sheet of labels to apply to the I/O panelettes as shown in Figure 6.
The label sheet has both printed labels and blank labels you can customize.
Connectors/Units
per Panelette
9
Slot Width
2 1
1 1
1 1
1 2
1 2
2 3
2 3
2 1
2 1
1 1
4 1
1 1
1 2
— —
SCC Quick Start Guide