Table of Contents
Advertisement
Step 11. Use Your Task in an Application
SCC Quick Start Guide
6.
Configure measurement-specific settings and scaling, if necessary.
7.
Save your configuration.
8.
Click Test. Verify your data in the window that opens. If the data is
incorrect, verify the settings in the DAQ Assistant window, and if
applicable, the TEDS information.
You now can use the global virtual channel in an application or add the
global channel to a task.
Complete the following steps to use a measurement task in your
application. Refer to the DAQ Assistant Help for more information about
using a task or generating code.
To run examples without hardware installed, you can use NI-DAQmx
simulated devices. In MAX, refer to the Measurement & Automation
Explorer Help for NI-DAQmx by selecting Help»Help Topics»
NI-DAQmx for instructions on creating NI-DAQmx simulated devices and
importing NI-DAQmx simulated device configurations to physical devices.
LabVIEW
1.
Open a blank VI in LabVIEW.
2.
Place the following constant on the block diagram: NI Measurement»
DAQmx-Data Acquisition»DAQmx Task Name Constant.
3.
Select the task from the pull-down menu.
4.
Right-click the VI and select Generate Code»Example.
5.
Run the program from the front panel.
LabWindows/CVI
Refer to
ni.com/info
using a task in LabWindows/CVI.
Measurement Studio
Refer to
ni.com/info
using a task in Measurement Studio.
and type
for step-by-step instructions for
rddq73
and type
for step-by-step instructions for
rddqms
32
ni.com
Advertisement
Table of Contents
