Step 8. Connect The Modules To The Daq Device; Single-Chassis System - National Instruments SCXI-1000 Quick Start Manual

Step 8. Connect the Modules to the DAQ Device

Single-Chassis System

© National Instruments Corporation
1 SCXI-1000 or SCXI-1001 Chassis
2 SCXI-1346 Cable Adapter
3 Shielded Cable Connecting to TO NEXT CHASSIS
4 Shielded Cable Connecting to FROM DAQ BOARD OR PREVIOUS CHASSIS
Figure 10. SCXI-1346 Cable Assembly
5. Install the SCXI-1349 cable adapter into the last SCXI chassis in
the chain. Refer to step 1 of the
instructions on installing the SCXI-1349.
If you installed modules in a PXI/SCXI combination chassis, the PXI
backplane of the chassis connects the modules and DAQ device.
If you are using an SCXI chassis, complete the following steps:
1. Connect either end of the 68-pin shielded cable to the SCXI-1349.
2. Connect the other end of the cable to the DAQ device. For M Series
devices, connect the cable to connector 0.
If you are running modules in parallel mode, repeat the steps for each
module and DAQ device pair.
S E
F U
L L
P U
P
T O
4
Single-Chassis System
13
1
2
3
section for
SCXI Quick Start Guide