National Instruments SCC Series Quick Start Manual page 21

SCC Modules
SCC-FT01
SCC-SGXX
© National Instruments Corporation
Table 3. SCC Modules and Dual-Stage Compatibility (Continued)
Single-Stage Analog
Input (J1–J8)
Yes
Yes
Digital SCC Modules
Sockets J9 to J16 work for digital SCC modules as well as for analog
inputs. Plug a digital SCC module into any socket J(X+9), where X is 0 to 7,
and connect the P0. signal to the module. The SC-2345 routes the P0. signal
to the DAQ device channel P0.(X). Figure 18 illustrates a digital module
with an analog input module.
3
4 2
1 SC-2345 Carrier
2 Input Signals
Figure 18. Single-Stage Analog Input and DIO SCC Configuration
Analog Output SCC Modules
You can plug analog output SCC modules into the SC-2345 using sockets
J17 and J18. Each socket connects to both analog output channels of the
DAQ device although each is identified on the SC-2345 as being for either
channel 0 or channel 1. These designations indicate the primary analog
output channel each socket uses. Analog output channel 0 is the primary
channel for socket J17. Analog output channel 1 is the primary channel for
socket J18.
GPCTR SCC Modules
You can build GPCTR circuitry onto the SCC-FT01 feedthrough module.
Plug the custom GPCTR SCC module into socket J19 or J20 of the
SC-2345. Socket J19 connects to the DAQ device GPCTR channel 0.
Socket J20 connects to GPCTR channel 1.
First Stage of Dual-Stage
Analog Input (J9–J16)
Yes
Yes
4
3 Digital SCC Plugged into J9
4 Analog SCC Plugged into J1
for SC-2345 Connector Block Socket
21
Second Stage of Dual-Stage
Analog Input (J1–J8)
Yes
No
1
SCC Quick Start Guide