Table of Contents
Advertisement
MAINTENANCE
5.2
Spare parts
It is possible to replace parts such as the valve, the piezoelectric or the ignition control unit (depending on
the type of appliance) or the gas pipes easily and quickly.
To replace such parts, proceed as follows:
· SWITCH: Remove the knob and open the panel, unscrew the two screws that fasten the switch/regulator
to the panel, remove all the electrical connections and proceed with replacement
· LEVEL CONTROL UNIT: disconnect the electrical connections that connect it to the sensor, unscrew the
screws that fasten it to the bottom of the appliance and replace it
· ROTARY HEATING ELEMENT; remove the panel and remove the wires connecting the heating element.
Unscrew the two 8 mm screws that fasten the bracket to the heating element and pull out the bracket
until it can be removed. At this point, the heating element can be removed from inside the bowl, pushing
it towards the draught diverter. Also replace the 3 o-rings (see point 1 in figure C) and apply a bit of
grease to facilitate the operation.
Note
It is recommended to replace the three o-rings once a year as they are subject to wear and, with
time, can cause leaks
Caution
WHAT TO DO IN THE EVENT OF FAULTS:
Close the gas connection cock and/or switch off the power using the up-line device. Notify
customer service.
Warning
MEASURES TO BE TAKEN IF THE APPLIANCE IS NOT TO BE USED FOR A LONG TIME:
Close the gas cock and/or disconnect the power supply. Clean the system as specified above.
Translation of the original instructions
23
Advertisement
Table of Contents
