Table of Contents
Advertisement
· Voltage 230V 50Hz
6.4
Minimum setting
· After conversion to use another type of gas, or if a flame is too high when the knob is in position
small flame), adjust the minimum setting by turning the by-pass screw. For operation with LPG, the
by-pass must be completely closed; for operation with natural gas, it must first be closed and then
opened by 1/4 turn
6.5
Spare parts
It is possible to replace parts such as the gas tap, thermocouple, spark plug or the gas pipes simply and
quickly.
To replace such parts, proceed as follows:
· GAS TAP: after disassembling the front panel, unscrew the gas connection screw couplings, remove the
coupling, replace the faulty parts and install the new ones in sequence
· THERMOCOUPLE: unscrew the pilot burner coupling, unscrew the gas tap coupling in the same way
and replace the element
· HEATING ELEMENTS; open the oven door and remove the wires connecting the heating element.
Unscrew the supports that fasten the oven to the enclosure and then replace it
Caution
WHAT TO DO IN THE EVENT OF FAULTS:
Close the gas connection cock and/or switch off the power using the up-line device. Notify
customer service.
Warning
MEASURES TO BE TAKEN IF THE APPLIANCE IS NOT TO BE USED FOR A LONG TIME:
Close the gas cock and/or disconnect the power supply. Clean the system as specified above.
Translation of the original instructions
24
MAINTENANCE
(
Advertisement
Table of Contents
