Table of Contents
Advertisement
5.2
Spare parts
It is possible to replace parts such as the valve, the piezoelectric or the ignition control unit (depending on
the type of appliance) or the gas pipes easily and quickly.
To replace such parts, proceed as follows:
· THERMOSTAT ; after removing the front panel, unscrew the two screws that fasten the thermostat to the
panel, then, after disconnecting all the electrical connections, replace the damaged parts and install the
new ones in succession
· POWER REGULATOR or SWITCH: Remove the knob and open the panel, unscrew the two screws that
fasten the switch/regulator to the panel, remove all the electrical connections and proceed with
replacement
· HEATING ELEMENT/PLATE ; remove the panel and remove the wires connecting the heating
element/plate. Unscrew the supports that fasten the heating element/plate to the hob. Once removed,
make the replacement. In the case of cooker hobs, the plate is removed from the top of the hob, and in
the case of glass-ceramic hobs (radiating heating element), it is removed from the bottom
Caution
WHAT TO DO IN THE EVENT OF FAULTS:
Close the gas connection cock and/or switch off the power using the up-line device. Notify
customer service.
Warning
MEASURES TO BE TAKEN IF THE APPLIANCE IS NOT TO BE USED FOR A LONG TIME:
Close the gas cock and/or disconnect the power supply. Clean the system as specified above.
All manuals and user guides at all-guides.com
Translation of the original instructions
24
MAINTENANCE
Advertisement
Table of Contents
