Model 68000 Installation, Operation and Maintenance ERTICAL LEARANCE Safety decals similar to those shown here are found on a properly installed lift. Be sure that all Check the height of the area where the lift is to safety decals have been correctly installed on the be installed.
Model 68000 Installation, Operation and Maintenance ECEIVING 2) Determine hose lengths. The three (3) required hoses SUPPLIED The shipment should be thoroughly inspected as because their lengths will be based on the soon as it is received. The signed bill of lading is...
Model 68000 Installation, Operation and Maintenance 7) Install a 90 degree cylinder adapter elbow, OWER Fig 6, (male 1/4BSPT x male #6 J.I.C. 37° 3) Install the power unit stand using concrete flare) to the upper and lower ports (1/4BSPT) anchors provided.
Model 68000 Installation, Operation and Maintenance NCHORING insure that the lift The Owner/Employer shall operators are qualified and that they are trained 14) There are (5) holes provided in the base of in the safe use and operation of the lift using the both frames, Fig 1.
Model 68000 Installation, Operation and Maintenance IFTING A EHICLE OWERING EHICLE 1) Be sure lift is fully lowered and service bay is 1) Insure that the area under the vehicle is clear of personnel and tools. clear of all personnel before the vehicle is driven on to lift.
Page 8
Model 68000 Installation, Operation and Maintenance ARTS REAKDOWN SLAVE SIDE (LH) SLAVE SIDE (LH) SLAVE SIDE (LH) SLAVE SIDE (LH) MASTER SIDE (RH) MASTER SIDE (RH) MASTER SIDE (RH) MASTER SIDE (RH) Page 8 7/14/05 68030 .doc...
Page 9
CYLINDER RESTRICTOR VALVE Replace all worn or broken parts with genuine Challenger Lifts Inc. parts. Contact your local Challenger Lifts Parts Distributor for pricing and availability. (Call Challenger Lifts Inc. (502) 625-0700 for the Parts Distributor in your area) Page 9 7/14/05 68030 .doc...