Crate size 26”w x 28”H x 128” L; 1220 lbs * Lift capacity ratings are based on loads equally distributed on lifting rails and TRAYs. Designed for use on Challenger Lifts Models: CL10, LE10, Q10, Symetric SA10, CLFP9, CL12, Q12, and E12 Page 2 Rev.
Do this for your own American National Standard for Automotive Lifts- protection. Safety Requirements for Operation, Inspection and Maintenance. Challenger Lifts NOTIFY AT ONCE if any hidden loss or damage is discovered after receipt. IT IS DIFFICULT TO COLLECT FOR LOSS OR...
Turf Rail Installation, Operation and Maintenance Make sure floor is clear between rails. Take each TRAY and mount it onto the rail, one TRAY IMPORTANT SAFETY INSTRUCTIONS forward of the columns and on TRAY rear of When using your garage equipment, basic safety the columns. precautions should always be followed, including AISING ROCEDURE the following: ENSURE THAT THE HIGHEST POINT ON THE 1. Read all instructions. EQUIPMENT WILL CONTACT THE OVERHEAD LIMIT 2. Care must be taken as burns can occur from SWITCH BAR. ...
Check for loose or broken parts. Check the adaptors for damage or excessive wear. Replace required with genuine Challenger Lifts parts. Weekly Visually Inspect Monthly Visually inspect If any problems are encountered, contact your local service representative.
Page 6
RUBBER SPOTTING BLOCK (OPTIONAL) IMPORTANT Replace all worn, damaged, or broken parts with parts approved by Challenger Lifts, Inc. or with parts meeting Challenger Lifts Inc. specifications. Contact your local Challenger Lifts parts distributor for pricing and availability. Call Challenger Lifts at (502) 625-0700 for the distributor in your area.