Canon SmartBase MPC600F/400 Fax Manual page 60

Message (Error Code)
ECM TX
MEMORY USED nn %
NO RX PAPER ( 012)
NO TEL # ( 022)
NOT AVAILABLE
REC'D IN MEMORY
RECEIVED IN FILE
TRY AGAIN IN B&W
( 085)
TX/RX CANCELLED
TX/RX NO. nnnn
TX nnnn
SCANNING P. nnn
MEMORY FULL
PLEASE WAIT
8-2
Cause
The machine is sending a fax using Error
Correction Mode (ECM).
Shows the percentage of memory
currently in use.
The other party's fax machine is out of
paper or its memory is full.
The one-touch speed dialling button or
coded speed dialling code you entered has
not been registered.
In manual sending via the handset, you
entered a speed dialling number that is
assigned to a group.
The machine received the fax in memory
because paper or ink ran out, or a paper
jam occurred.
Your PC was off and a document was
received in the machine's memory.
The MultiPASS Status Monitor is not
running. (Windows 95/98/Me)
You tried sending a colour document to a
machine that does not support colour
faxing.
You pressed Stop/Reset to cancel the
transmission.
When the machine sends or receives a fax,
it assigns it a unique identification number
(nnnn).
The machine is sending a document and its
memory is full.
Action
ECM transmissions may take longer than
normal transmissions. Turn off ECM if
you need to transmit quickly, or if you
know your local lines are in good
condition. ( ECM TX, p. 9-5)
If you need more space, wait for the
machine to send any faxes. Also, print or
delete any documents in memory you no
longer need. ( pp. 4-14, 4-15)
Contact the other party and have them
load paper in their fax machine or free up
space in their fax machine's memory.
Register the one-touch speed dialling
button or coded speed dialling code.
( pp. 3-2, 3-4)
Use regular dialling, or enter a one-touch
speed dialling button or coded speed
dialling code that only has one fax/
telephone number registered.
Load paper in the multi-purpose tray
( Quick Start Guide), replace the Ink
Tank(s) ( Reference Guide), or clear
the paper jam. ( Reference Guide)
Upload the document to your PC, or print
the document. ( pp. 4-14, 5-5)
®
On the Windows desktop, click Start
and point to Programs. On the Programs
menu, point to MultiPASS Suite, then
click MultiPASS Status Monitor.
Try sending again in black & white
( p. 4-1). Alternatively, enable the
COLOUR DIRECT TX setting.
( p. 9-6)
If required, try sending or receiving
again.
Write the number down if you will need it
later.
The machine continues to send the
document as memory becomes available.