Vogt WorkTec VH10 Translation Of The Original Operating Manual page 29

Breaks from work
Ending work
Putting into storage
Operating the VOGT Hammer / TurboSpade
US edition 2021/10
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.com
Use of the VOGT Hammer / TurboSpade can cause unpleasant sensations
in the hands, arms, shoulders, chest, or other parts of the body while per-
forming work-related tasks.
If you experience symptoms such as persistent discomfort, pain, throb-
bing, aching, itching, deafness, burning, or stiffness, you should not ignore
the warning signs. Stop work, tell your employer, and consult a physician.
When taking breaks from work, remember the following points:
Lay the compressed air device down in such a way that the rammer
„
cannot be activated unintentionally from the trigger lever.
Make sure that the compressed air device is lying or standing securely
„
and cannot tip or fall over.
If there are any sharp or pointed tools inside the compressed air de-
„
vice, make sure that nobody can injure themselves on them. Put the
blade protection back onto Frankenklinge, cutting, or cross blades as
well as the protection for the injection tube.
After ending work, remember the following points:
Always disconnect the compressed air supply.
„
Remove the tool from the compressed air device (see Chapter 5.1).
„
Check whether the chisel holder is covered with a film of oil. If not,
„
drop a few drops of VOGT Special Oil Z 500 into the connecting hose
and operate the compressed air device without a tool for about ten
seconds. The compressed air will push the oil into the rammer. Adjust
the oiler accordingly.
If putting the device into storage for more than two days, drop a few drops
of oil into the connecting hose to preserve it and operate the device brief-
ly. The compressed air will push the oil into the rammer.
1. Place the tool on the workpiece to be worked.
2. Use your hand to operate the trigger lever. It must never be locked in
place using any auxiliary equipment.
3. The rammer on the compressed air device drives the tool into the
material to be worked.
4. Release the trigger lever as soon as the workpiece has been worked as
desired.
VH / VTS / VBL / VAI Translation of the original operating manual
Safe use
Subject to change without notice
29