Table of Contents
Advertisement
Series 2000/3000 IDU User's Manual
Revision P4
!CFG: Filter patterns with same subnet linked
to different IPSEC servers (<FP1#> and
<FP2#>)
!CFG: Enabling IPSEC for OAM queue is not
allowed (<SQ#>)
!CFG: SAT queue linked to invalid IPSEC
server (<SQ#>)
!CFG: Filter pattern linked to invalid SAT
queue (<FP#>)
!DWNL: Cannot find specified SIT image
(<sitimagepath>).
!DWNL: Current SIT image was not vali-
dated, toggled to Alternate SIT image.
!RLINK: Signalling Data Invalid
(<tablename>)
!RLINK: Center Frequency Out of Range
!SYNC: Start of Frame Timeout
!SYNC: PCR Missing
!SYNC: PCR Reload
!SYNC: PCR Absence Detected
!SYNC: Missing CMT
!SYNC: Timing Correction Outside Threshold
!FLINK: Signalling Table Format Invalid
(<tablename>)
!FLINK: L-Band Frequency Out of Range
!FLINK: Symbol Rate Out of Range
!RADIUS: User Authentication Failed
(<username>)
!IPSEC: SIT Security Association Negotiation
Failed (<mode>)
Page 37
Table 13:
Where <FP#> is a filter pattern number.
Where <SQ#> is a SAT queue number.
This usually happens when the new software
image was not validated after 10 minutes.
Where <tablename> is the name of the
signalling with invalid data.
The transmit frequency must be within
range of the IDU's transmit frequency
plus the ODU Tx mixing Frequency (See
IDU Installation Manual
Usually a temporary error.
The IDU does not receive a response to its
SYNC burst sent to the Hub.
Where <tablename> is the name of the
signalling with invalid data.
This is the configured frequency minus
the ODU Rx mixing frequency. It must be
within the IDU's L-Band frequency range
Where <username> is the name of the
user who failed authentication.
Where <mode> is either main or quick
mode.
section
2.5).
Advertisement
Table of Contents
