EMS 2000 IDU Series User Manual page 31

Series 2000/3000 IDU User's Manual
Revision P4
Status of SIT authentication.
• Not Enabled. RADIUS is disabled according to RADIUS enable flag (see
RADIUS Configuration).
• Authentication Requested. The IDU has sent an authentication request but
Authentication
has not received a reply. In addition, the request has not yet timed out.
State
• Not Authenticated. The IDU has not yet started its RADIUS authentication
with the RADIUS server in the hub.
• Authenticated. The IDU has successfully authenticated with the RADIUS
server in the hub.
IDU Power
Shows the current setting of the IDU output power level attenuation, in dB.
Level
Indicates that the IDU is enabled or disabled for transmission along the return
link. It is normally enabled unless disabled by the hub or by the IDU Control
IDU Tx Status web page (see
or "Initialized" (see above), the transmit status may show "Enabled" but no
transmission will occur.
Shows the IDU's signal to noise ratio on the return link, as measured by the
RL Measured
hub. The value is sent to the IDU via the forward link. The value is expressed
Eb/No
in dB.
Shows the Logon ID assigned by the hub for the current session. The value
Logon ID
65535 is displayed until the session logon ID is received from the hub.
Shows the Group ID assigned by the hub for the current session. The value
Group ID
255 is displayed until the session group ID is received from the hub.
Shows the current Return Link Burst Type. The RL Burst Type is
"Unknown" until the SIT receives the logon descriptor in the TIM. At
RL BurstType
that time, the Return Link Burst Type can be either "ATM" or
"MPEG".
Shows the current setting for the OAM VPI as set through a TIM message
OAM VPI once synchronisation has occurred. This is only displayed when the return
link burst type is ATM.
Shows the current setting for the OAM VCI as set through a TIM message
OAM VCI once synchronisation has occurred. This is only displayed when the return
link burst type is ATM.
Shows the current setting for the Traffic VPI when the SIT transitions from
"OamActive" to "Active" state. This is only displayed when the return link
Traffic VPI
burst type is ATM.
See section 3.1.1
Shows the current setting for the Traffic VCI when the SIT transitions from
"OamActive" to "Active". This is only displayed when the return link burst
Traffic VCI
type is ATM.
See section 3.1.1
Page 27
Table 7:
section 2.2). Note that when the SIT operational state is "Idle"
for a description of where the traffic VCC value is taken.
for a description of where the traffic VCC value is taken.