Canon VK-64 Administrator's Manual page 261

Messages
ERROR(http): socket
type=(IMAGE/EVENT/
COMMAND),
cameraserver=(<host>:<
port>)
http_status=(<HTTP
error code>)
Failed to write camera
configuration file
ERROR: Out of memory
-- please check
configuration of this PC
Camera <camera>
Effective recording rate
(y%->z%)
ERROR(http): socket
type=(Image),
cameraserver=(<host>:<
port>) http_status=400
Cause
An HTTP error occurred when
connecting to the camera server.
IMAGE == Get image process
EVENT == Get camera server
status process implemented by
GetNotice
COMMAND == Camera server
operation/configuration change
command process
Cannot overwrite the camera
server configuration file. The
setting changes conducted after
the recording engine started
cannot be saved.
Failed to reserve memory in the
recording engine since the
system memory is under a heavy
load because unprocessed
frames continued to increase. An
application error will occur in a
few seconds and the Storage
Server functions will stop.
The recording frame rate has
been changed from y% to z%
because the load of the recording
engine continued to increase
(decrease).
An HTTP 400 error occurred
when getting the image.
List of Messages
Action
Refer to the corresponding
HTTP error code in "A List of
Error Codes in Log File"
(➝ P. 263).
Check to ensure that you have
the write privilege for the
LocalSystem account in the VK-
64/VK-16 configuration
directory.
Reduce the system load using
the following methods.
1) Reduce the amount of data to
record (For example, lower
the resolution or frame rate).
2) Install an additional hard disk.
3) Implement an action such as
upgrading the CPU, or
increasing memory or existing
hard disk space.
Even though there is no
necessary action, you can
reduce the system load using
the following methods if you
want to avoid frame rate
decrease events.
1) Reduce the amount of data to
record (For example, lower
the resolution or frame rate).
2) Install an additional hard disk.
3) Implement an action such as
upgrading the CPU, or
increasing memory or existing
hard disk space.
It may be connected to SNC-P5,
DF40N in the MPEG mode.
Change it to the JPEG mode.
For other causes, refer to the
corresponding HTTP error code
in "A List of Error Codes in Log
File" (➝ P. 263).
9
261