Canon VK-64 Administrator's Manual page 254

List of Messages
Extracting Video
Adding/Editing a
Camera Server
Add/Edit Camera
Server dialog,
Add/Edit
Recording
Schedule dialog,
Motion Detection
Settings dialog,
Sensor Event
Settings dialog
Add/Edit
Recording
Schedule dialog
Add/Edit
Recording
Schedule dialog,
Motion Detection
Settings dialog
Camera
Summary
window
254
Messages メッセージ
Nothing could be saved because no
video was recorded at the specified
time.
The recording settings of this
camera server are not configured
but the server has already been
registered. Check the settings and
try again.
Could not connect to the camera
server. Check the entered
information.
'Communication Error Messages -
Details'
The connection to the camera
server has been disconnected.
An error relating to the camera
server connection occurred.
Specify the day.
Specify the recording mode.
Specify the recording frame rate
between 'fps' and 'fps'.
The maximum value of the pre-
event recording is 30 seconds.
The change cannot be saved
because it cannot be sent to the
Storage Server 'Storage Server
name'.
'Communication Error Messages -
Details'
Cause 原因
There are no recorded videos for the
selected segment thus they could not
be saved.
When a camera server configured as
Do not record is already added, an
attempt was made to add or edit a
camera server using the same hot
name/IP address and port number.
Could not connect to the camera
server.
An error relating to the camera server
connection occurred.
An unknown error relating to the
camera server connection occurred.
OK was pressed without specifying
the day.
OK was pressed without selecting
the recording mode check box.
An invalid recording frame rate was
entered.
OK was pressed after configuring a
value exceeding 30 seconds for the
pre-event time value.
An error occurred while saving the
settings in the Camera Summary
window.