Setting Motion Detection Recording
●
Set the Sensitivity
Sensitivity is the degree of change detected as motion.
Drag the slide bar to adjust Sensitivity to the desired value (depending on the
2
range setting).
Note
●
Set the Area Ratio
Area Ratio is the degree of change of area (ratio against the defined detection area)
detected as motion.
Area Ratio marker.
122
The Motion Detection settings are affected by the video quality
setting of the Camera Server. After configuring the Motion
Detection settings, do not change the video quality on the
Camera Server.
When you drag the slide bar, the black vertical line in the Detection
Indicator will move to reflect the change in specified Area Ratio.
Select Low-Med or Med-High. The
1
available sensitivity settings range
from 1 to 256.
You can specify 1 through 128 as
Sensitivity by clicking Low-Med and
129 through 256 by clicking Med-High.
Click and drag the Area Ratio slide bar to
any position from 0% to 100%. This
establishes the proportion of image inside the
Active Region (dotted frame) allowed before
motion is detected.