End Position Closed (Black Section): Set; End Position Open (White Section): Set - AUMA SAEx 25.1 Operation Instructions Manual
Multi-turn actuators, control unit - electromechanical with actuator controls, on wall bracket
Hide thumbs
Also See for SAEx 25.1:
- Operation manual (100 pages) ,
- Operation instructions manual (56 pages) ,
- Manual (48 pages)
Table of Contents
Advertisement
Commissioning (basic settings)
9.5.1.
End position CLOSED (black section): set
9.5.2.
End position OPEN (white section): set
68
Figure 84: Setting elements for limit switching
Black section:
[1]
Setting spindle: End position CLOSED
[2]
Pointer: End position CLOSED
[3]
Mark: End position CLOSED is set
White section:
[4]
Setting spindle: End position OPEN
[5]
Pointer: End position OPEN
[6]
Mark: End position OPEN is set
1.
Engage manual operation.
2.
Turn handwheel clockwise until valve is closed.
3.
Turn handwheel by approximately half a turn (overrun) in the opposite direction.
4.
Press down and turn setting spindle [1] with screw driver in direction of the
arrow and observe the pointer [2]: While a ratchet click is felt and heard, the
pointer [2] moves 90° every time.
5.
As soon as the pointer [2] is 90° from mark [3]: Continue turning slowly.
6.
As soon as the pointer [2] moves to mark [3]: Stop turning and release setting
spindle.
The end position CLOSED setting is complete.
7.
If you override the tripping point inadvertently (ratchet click is heard after the
pointer has snapped): Continue turning the setting spindle in the same direction
and repeat setting process.
1.
Engage manual operation.
2.
Turn handwheel counterclockwise until valve is open.
3.
Turn handwheel by approximately half a turn (overrun) in the opposite direction.
4.
Press down and turn setting spindle [4] with screw driver in direction of the
arrow and observe the pointer [5]: While a ratchet click is felt and heard, the
pointer [5] moves 90° every time.
5.
As soon as the pointer [5] is 90° from mark [6]: Continue turning slowly.
6.
As soon as the pointer [5] moves to mark [6]: Stop turning and release setting
spindle.
The end position OPEN setting is complete.
7.
If you override the tripping point inadvertently (ratchet click is heard after the
pointer has snapped): Continue turning the setting spindle in the same direction
and repeat setting process.
SAEx 25.1
SAEx 40.1 / SAREx 25.1
SAREx 30.1
ACExC 01.2
Advertisement
Table of Contents
