7100 Calibration Bath
User's Guide
7.5
26
1) The access hole in the lid may be used for filling the bath and inserting
devices into the bath. Normally this hole should be covered to insulate
the bath. Covers may be purchased separately from Hart Scientific.
2) The motor on the lid drives the stirrer on the standard lid and the pump
on the optional pump lid.
3) The probe hole is for inserting the control probe into the bath.
Fluid Level Adapter
The fluid level attachment connects to the fluid well by means of a bayonet
type mount (see Figure 6). It's cover is attached by four screws and the sight
glass sits on the cover. It is designed to bring the fluid level to the top of the lid
for convenience in observing the meniscus of liquid-in-glass thermometers.
Figure 6 Fluid Level Adapter