Gold's Gym PRO Series User Manual page 10

9. Grease an M10 x 182mm Button Bolt (63). Attach
the Seat Frame (11) and the Backrest Frames (12)
to the Seat Carriage (22) with the Button Bolt and
an M10 Nylon Locknut (66). Do not overtighten
the Nylon Locknut; the Seat Frame and the
Backrest Frames must pivot easily.
Insert the Medium Pin (45) through a hole in the
Seat Frame (11) and the tube on the Seat
Carriage (22).
See the inset drawing. Grease an M10 x 82mm
Hex Bolt (72). Attach the Backrest Support (13) to
the Bench Frame (3) with the Hex Bolt and an
M10 Nylon Locknut (66). Do not overtighten the
Nylon Locknut; the Backrest Support must
pivot easily.
See step 8. Tighten the four M6 x 47mm
Screws (67).
10. Grease an M10 x 82mm Button Bolt (54). Attach
the Leg Lever (10) to the Front Leg (9) with the
Button Bolt and an M10 Nylon Locknut (66). Do
not overtighten the Nylon Locknut; the Leg
Lever must pivot easily.
11. Insert the Long Pad Tube (71) into the Front Leg
(9). Slide two Round Pads (17), with Pad Covers
(39), onto the Long Pad Tube.
Repeat this step with the two Short Pad Tubes
(18) and the Leg Lever (10).
9
66
45
12
11
Tube
10
10
11
39
17
71
10
18
10
Grease
63
22
66
Grease
13
72
3
9
66
54
Grease
9
17
18
39