Table of Contents
Advertisement
10. ATTACH CAM ARMS (F) to cranks on bat
assemblies using 5/8 x 1-3/8 hex head shoulder
bolts and lock nuts. Finger tighten only.
NOTE: There are two positions on the crank for
connecting cam arms. See "Recommended
Settings" chart on page 14 and choose the
position best suited to your conditions. (Position
"Y" is shown here.)
IMPORTANT: Install hardware with bolt head
inboard. Once a cam arm position is chosen,
ensure all arms are in the same position at both
ends of the reel.
11. INSTALL FINGERS in bats using tool (A)
provided, ensuring button snaps into hole (B) in
bat.
For steel fingers, pre-assemble finger (F) and
clip (G) and install as above.
Form 46240
ASSEMBLY
B
10
F
ATTACH CAM ARMS
A
INSTALL FINGERS
G
F
STEEL FINGERS
Issue 06/06
Advertisement
Table of Contents
