Table of Contents
Advertisement
SAFETY SIGNS
• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing or become illegible.
• If original parts on which a safety sign was installed are replaced, be sure the repair part also bears the
current safety sign.
• Safety signs are available from your Dealer Parts Department.
• To install safety signs:
1. Be sure the installation area is clean and dry.
2. Decide on the exact position before you remove the backing paper.
3. Remove the smaller portion of the split backing paper.
4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is applied.
5. Small air pockets can be smoothed out or pricked with a pin.
• The following safety sign appears on the pick-up reel main tube.
• As well, the following or similar reel-related safety signs may appear on your combine or windrower
header.
Form 46240
SAFETY
4
Issue 06/06
Advertisement
Table of Contents
