Table of Contents
Advertisement
8. ATTACH CRANKS TO BAT ASSEMBLIES:
a. Left and right cranks are bundled separately.
Identify left and right cranks by the decal on one
crank per bundle.
b. Install left (E) and right cranks into bat
assemblies (F). Be sure orientation of bats is
as shown.
At Left Cranks Only: Fasten with 5/16 NC x
1-1/2 inch hex socket head capscrews and
special tapered nuts (H). (Taper against bat).
Tighten hardware only until bat is clamped to
tube (0 to 1 ½ threads showing). Do not
collapse bat and tube by over-tightening.
IMPORTANT: Do not install hardware for right
cranks at this stage. This hardware will be
installed at Step 15.
c. 36' Header Only: At inboard end of L/H and R/H
reels, install fingers in end bats. (See Step 11
for procedure). Install 5/16 NC x 3/4 carriage
bolt and flange nut at (D), tightening only until
fingers are clamped.
Attach end bats to bat assemblies similar to
cranks, (Step 8 b, above).
NOTE: Clamping of end bat fingers prior to
installation of end bat is necessary to provide
proper fit-up between end bat and formed bat.
9. ATTACH BATS TO REEL ARMS:
a. Assemble bearing halves (A) and steel strap (B)
onto reel bats.
NOTE: Apply a thin layer of grease on all plastic
bearings to prolong bearing life.
b. Check that left and right hand decals on bat
assemblies and cam assemblies match. Attach
bats to reel arms (C) as shown with 5/16 x 2 1/4
inch hex head capscrews and flange locknuts
(D). FINGER TIGHTEN ONLY.
c. Straighten bats, then tighten hardware at arm
discs only. See Step 14 for proper torques.
WARNING: Do not crawl under, or
climb over or through the reel
assembly.
Form 46240
ASSEMBLY
INSTALL CRANKS INTO BATS -
FASTEN LEFT HAND ONLY
CLAMP FINGERS IN END BATS BEFORE
INSTALLATION (36' HEADER ONLY)
9
H
F
D
ATTACH BATS TO REEL ARMS
E
Issue 06/06
Advertisement
Table of Contents
