Table of Contents
Advertisement
SYMPTOM
REEL DELIVERY (continued)
Early wear and/or
destruction of cam
components.
Premature destruction of
cam arm bearings.
Destruction of end shields.
CONVEYOR FEEDING
Crop builds up on
conveyors.
Bunchy feeding from
cutterbar to conveyors.
* - See your Header or Power Unit Operator's Manual.
Form 46240
TROUBLESHOOTING
PROBLEM
Reel adjustments not the
same at both ends of
reel.
Cam arms bent, causing
bearing misalignment.
Reel not centered in
header.
Cutterbar too low.
Conveyor speed too
slow.
Reel too far back.
Reel speed too fast.
Reel too low.
Ground speed too fast.
Reel too far forward.
Reel too high.
Reel speed too slow.
Cutterbar too high.
Ground speed too slow.
20
SOLUTION
Adjust cam arm position,
finger pitch range slot and
notch to same at both ends.
Straighten cam arms to set
bearings parallel.
Center reel in header.
Raise cutting height.
Increase conveyor speed.
Move reel forward
Reduce reel speed.
Raise reel.
Reduce ground speed.
Move reel back on support
arms.
Lower reel.
Increase reel speed.
Lower cutting height.
Increase ground speed.
REF.
14
---
*
*
*
*
*
*
*
*
*
*
*
*
Issue 06/06
Advertisement
Table of Contents
