Operation; Assembling The Collection Bag For Sandblasting Material (Pre-Assembled); Selecting And Assembling An Attachment; Filling The Blasting Material Holder - Parkside PDSP 1000 D5 Operation And Safety Notes

Wear a dust mask!
Wear protective glasses!
Wear ear protection!
Wear protective gloves!
Wear protective clothing!
EXPLOSION HAZARD! Do not
use the air sand blaster gun in envi-
ronments containing gases, open
flames, fires or gas-operated water heaters.
SMOKING PROHIBITED!
Only work in well ventilated spaces.
Never use oxygen or other flammable gases
as an energy source.
Never exceed the maximum permitted operat-
ing pressure of 6.3 bar.
FORCES! High operating pressures can give rise
to recoil forces that under certain conditions
can result in danger from continuous loading.
RISK OF INJURY! Remove the product from
the compressed air source before repair and
maintenance work and before transport.
RISK OF INJURY! Remove the product from
the compressed air source to fill the product
with blasting material.
NOTE! Please note the safety information of the
manufacturer of the blasting material.
Only use suitable materials for the air sand
blaster gun. Use a suitable blasting material!
ATTENTION! Heavy dust forma-
tion. Take precautions!
Make sure that the sandblasting material is
collected so that you can dispose of it in an
environmentally-friendly way.
Do not remove any markings/type plates.
These are safety-relevant.
8 GB
RISK OF RECOIL
If you are inexperienced in the use of this type
of product, you should seek training to learn
how to handle it safely.
WARNING! NOXIOUS DUST! Working
on materials which can produce harmful / toxic
dusts presents a health risk to the user and peo-
ple within close vicinity.
CAUTION! Ensure that the product
is disconnected from the air supply
when it is not in use, when replacing
accessories or when carrying out repair work.
The air hose must not be pressurised.

Operation

Assembling the collection bag
for sandblasting material
(pre-assembled)
Use the screw clamp
7
contents and a screwdriver to assemble the
collection bag on the product.
6
Selecting and assembling an
attachment
First, select the attachment (
which is suitable for your work.
Place the attachment you have selected onto
the jet nozzle and ensure that no air can
8
leak from the sides.
Filling the blasting
material holder
CAUTION! Before opening the screw cap
of the blasting material holder
other settings, the pressure must always be fully
relieved and the air sand blaster gun discon-
nected from the compressed air source (i.e.
compressor).
Only use a suitable blasting material for your
work .
14
included in the delivery
, , , )
10 11 12 13
2
or configuring
1