Tank Draining; Battery Charging - Viper TP24TSCRUB Owner's Manual

5. When the solution tank runs empty, turn off
the brush switch, solution switch and raise
the brush head. Keep the squeegee down
and continue to vacuum until all the dirty
water is picked up. (see TANK DRAINING
section to learn how to drain recovery and
solution tanks)
The brush motors are
circuit breaker protected
to protect them from damage. If a breaker
trips, it can't be reset immediately. You
must first determine what caused the
breaker to trip, and allow the motor to cool
down before you can reset the breaker. The
breakers are located on the back panel of
the control housing.

TANK DRAINING

1. Turn the power off on the machine
2. With the squeegee and brush head in their
"up" position, transport machine to
approved area for draining tank(s).
DRAINING THE RECOVERY (DIRTY) TANK
Anytime scrubbing is
completed, or when
refilling solution tank, the recovery tank
should be drained and cleaned.
If the recovery tank is not
drained when the solution
tank has been refilled, foam or water may
enter the float shut-off mechanism and
cause damage to the vacuum motor.
1. Remove the drain hose from the holder, and
place the drain hose over the floor drain.
Twist off the drain hose plug to begin the
draining process. In order to completely
empty the recovery tank, hinge open the
recovery tank and let it rest on the support
stand.
2. Clean the recovery tank after every use. Use
a fresh water hose to rinse out the recovery
tank. Be careful not to spray water into the
float shut-off mechanism.
All manuals and user guides at all-guides.com
time, always leave the clear recovery tank
lid off the tank so the tank can dry
completely and smell fresh.
3. Replace the drain hose plug tightly as soon as
the solution tank should be drained and
cleaned.
1. Pull down on the clear tube (back left of the
2. Rinse the solution tank with clean water after
3. With clean water in solution tank, turn
4. Once tank is rinsed, flushed and drained,
following specifications:
batteries charged at all times. Do not let
them sit in a discharged condition.
7
If you are storing the
machine for any period of
you are done draining the tank.
DRAINING THE SOLUTION (CLEAN) TANK
Anytime scrubbing
operation is completed,
machine) to remove it from the hose barb.
This will allow the solution to flow freely into
a bucket or floor drain.
every use. This will help prevent chemical
buildup and clogging of the solution lines.
machine power on, solution switch "on" and
pull the operating triggers. This will allow
the clean water to flush through and clean
the solution plumbing.
reconnect the clear tube to the hose barb. Be
sure the tube is pushed all the way up on the
hose barb.

BATTERY CHARGING

Use only approved
chargers with the
x
Automatic shut off circuit
x
Deep cycle charging
x
Output current of 10 – 20 amps
x
Output voltage of 24 volts
For the best machine
performance, keep