Safety Guidelines - ADJ MB DMX II User Manual

S A F E T Y G U I D E L I N E S
This device is a sophisticated piece of electronic equipment. To guarantee a smooth operation, it is important to
follow all instructions and guidelines in this manual. ADJ PRODUCTS, LLC. is not responsible for injury and/or
damages resulting from the misuse of this device due to the disregard of the information printed in this manual.
Only the original included parts and/or accessories for this device should be used. Any modifications to the
device, included and/or accessories will void the original manufactures warranty and increase the risk of damage
and/or personal injury.
PROTECTION CLASS 1 – DEVICE MUST BE PROPERLY GROUNDED
DO NOT ATTEMPT TO USE THIS DEVICE WITHOUT BEING FULLY TRAINED ON HOW TO USE
IT. ANY DAMAGES OR REPAIRS TO THIS DEVICE OR ANY LIGHTING FIXTURES CONTROLLED
BY THIS DEVICE RESULTING FROM IMPROPER USE, AND/OR THE DISREGARD OF THE
SAFETY AND OPERATION GUIDELINES IN THIS DOCUMENT VOIDS THE ADJ PRODUCTS,
LLC WARRANTY, AND ARE NOT SUBJECT TO ANY WARRANTY CLAIMS AND/OR REPAIRS,
AND MAY ALSO VOID THE WARRANTY FOR ANY NON-ADJ PRODUCTS, LLC DEVICES.
KEEP FLAMMABLE MATERIALS AWAY FROM DEVICE.
DRY LOCATIONS USE ONLY!
DO NOT EXPOSE DEVICE TO RAIN, MOISTURE, AND/OR SEVERE ENVIRONMENTS!
DO NOT SPILL WATER AND/OR LIQUIDS ON OR INTO THE DEVICE!
AVOID brute force handling when transporting or operating.
DO NOT expose any part of the device to open flame or smoke. Keep device away from heat sources such as
radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat.
DO NOT use device in extreme and/or severe environments.
DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power cord connectors
are damaged and do not insert into the fixture securely with ease. NEVER force a power cord connector into the
fixture. If the power cord or any of its connectors are damaged, replace it immediately with a new one of similar
power rating.
Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
Always disconnect device from main power source before performing any type of service and/or cleaning
procedure. Only handle the power cord by the plug end, never pull out the plug by tugging the wire portion of the
cord.
Consistent operational breaks will ensure fixture will function properly for many years.
ONLY use the original packaging and materials to transport the fixture in for service.
6